RAP 3-JAW Pneumatic Lathe Chuck | Taiwan AUTOGRIP® Pneumatic Power Chuck Supplier

Pneumatic Power Chuck

Pneumatic Power Chuck | 3-JAW

pneumatic chuck for the lathe.
Rotary chuck with built-in apneumatic cylinder, compact design, suitable for light machining. compatible to standard soft jaw/hard jaw.
Can be installed on a rotary table for indexing machining.
Sealed against dust and cutting chips.
Matching surfaces of all parts hardened, ground, and lubricated directly.
Note: To overcome friction force between distubritor ring and chuck body, the rotating torque of the rotary table must be higher than the requirement shown in the table.

Add to inquiry

Catalog Download Manual Download

Model	Jaw stroke (Dia.)(mm)	Chucking Dia. Max.(mm)	Chucking Dia. Min.(mm)	Max. clamping force (Pneumatic at 6.0kgf/cm²) kN (kgf)	Max. pressure (kgf/cm²)	Max. speed (r.p.m.)	Max Rotation Reslstance Torque (Nm)	Air Consumption (at 6.0 kgf/cm²) lit (kgf/cm²)	Weight (kg)
RAP-306	5.5	170	25	21(2141.4)	7	72	40	3.1	16.2
RAP-308	6.8	215	37	34.2(3487.4)	7	60	60	3.1	30.6
RAP-310	7	254	53	48(4894.7)	7	53	85	4.2	42.4

* Subject to technical changes.

Model	A	B	B1	C (H6)	D	E	F	G	H	J	K	L	L1	M	N	P	Q max.	Q min.	R max.	R min.	S	T	U	V	W
RAP-306	215	98	90	110	155	181	170	25	7	52	8	6~M8	11	36	73	20	10.75	4.75	39.5	36.75	31	12	19.5	14	3~M8
RAP-308	260	113	104	110	200	226	215	32	8	52	9	6~M8	16	37	95	25	13.25	8.75	57	53.6	35	14	19.5	14	3~M8
RAP-310	300	117	52	140	235	261	254	54	8	52	10	6~M8	14	42	110	30	23.25	12.75	64.5	61	40	16	19.5	14	3~M8

Automatic clamping solution for rotary table

RAP